Retsch Mixer Mill MM 500 nano, Manual

Page: 23 / 95

Packaging, Transport and Installation
23
4.3 Temperature Fluctuations and Condensation
NOTICE
N5.0016
Damaged components due to condensation
Temperature fluctuations
−
The device may be exposed to substantial fluctuations in temperature
during transport. The ensuing condensation can damage electronic
components.
•
Wait until the device has acclimatised before putting it into service.
Temporary storage:
Also in case of an interim storage the device must be stored dry and within the specified
ambient temperature range.
4.4 Conditions for the Installation Site
CAUTION
C5.0047
Risk of injury caused by the device falling
Incorrect installation of the device
−
Due to its weight, the device can cause injuries if it falls.
•
Only operate the device on a sufficiently large, strong and stable
workstation.
•
Ensure that all of the device feet are securely supported.
NOTICE
N6.0004
Setting up the device
Vibrations during operation
−
Depending on the operating mode of the device, slight vibrations may
occur.
•
Set up the device only on a vibration-free, plane and stable surface.
NOTICE
N7.0002
Setting up the device
Disconnecting the device from the mains
−
A separation of the device from the mains must be possible at any time.
•
Set up the device in such a way, that the connection for the power
cable is always easily accessible.
NOTICE
N8.0021
Ambient temperature
Temperatures outside the permitted range
−
Electronic and mechanical components may be damaged.
−
The performance data alters to an unknown extent.
•
Do not exceed or fall below the permitted temperature range (5 °C to
40 °C ambient temperature) of the device.
−
Maximum relative humidity < 80 % (at ambient temperatures
≤ 31 °C)