Respironics DreamStation, Service & Technical Reference Manual

Page: 101 / 135

P
AGE
6-28 1117539, V
ER
. 07
6.3 C
LEANING THE
T
HERAPY
D
EVICE
F
OR
O
NE
U
SER
1. Unplug the therapy device, and wipe the outside of it with a cloth slightly dampened with water and
a mild detergent. Let the device dry completely before plugging in the power cord.
2. Inspect the therapy device and all circuit parts for damage after cleaning. Replace any damaged
parts.
6.4 C
LEANING FOR
M
ULTIPLE
U
SERS
If you are using the therapy device and/or link module on multiple users, complete the following steps to clean
the therapy device and/or link module before each new user.
1. Before cleaning, unplug the therapy device and remove the link module. Also remove the blue pol-
len filter and light-blue disposable ultra-fine filter (if using).
2. Clean the outside of the therapy device and link module only. Use a cloth with one of the following
cleaning agents to clean the exterior of the device and link module:
•
Mild Detergent
•
70% Isopropyl Alcohol
•
DisCide Towelettes
•
10% Chlorine Bleach solution
3. Allow the therapy device to dry completely before plugging in the power cord and re-inserting the
filter(s).
WARNING
To avoid electrical shock, always unplug the power
cord from the wall outlet before cleaning the device.
CAUTION
Do not immerse the device in liquid or allow any liquid
to enter the enclosure, inlet filter, or any opening.
WARNING
If you are using the therapy device on multiple users, discard the bacteria filter each time the
therapy device is used on a different person.
NOTE
When using the therapy device on multiple users, it is recommended to use the “Reset Data”
option before each new user. Refer to Reset Data under Device Settings in section 4.10.4 of this
manual for additional information.
NOTE
The device is not intended for high level disinfection.