22
Stylus alignment
Stylus level setting
1. Check angular misalignment across front face
of the cube in both X and Y (top to bottom
and side-to-side) relative to the machine
datum. The recommended target is ±10
μ
m
(393.70
μin)
across any side face.
2. Starting with the greatest angular error,
loosen and then tighten M4 screws until
desired setting is achieved in both axes.
IMPORTANT:
Tighten adjusting screws to
2.60 Nm to 2.70 Nm (1.92 lbf. ft. to 1.99 lbf ft)
between adjustments.
M4 adjusting screws
2.60 Nm to 2.70 Nm
(1.92 lbf. ft. to 1.99 lbf ft)
M4 adjusting screws
2.60 Nm to 2.70 Nm
(1.92 lbf. ft. to 1.99 lbf ft)
Summary of Contents for APCA-45
