Unit description
Schematic depiction of the workings of the SLE 45-85 air dehumidifier
Moist room air
Warmed and
dehumidified air
The units may be used
to dehumidify areas such as:
■
Private swimming pools
■
Spa areas
■
Fitness centres
■
Storage rooms
■
Archives
■
Museums
The units have been designed for
universal and straightforward air
dehumidification.
Their compact dimensions allow
the units to be transported and
installed with ease in the adjacent
room.
The units operate in accordance
with the condensation principle
and are equipped with a
hermetically sealed refrigerant
system and low-noise and low-
maintenance fan(s).
The fully-automated electronic
controller, an integrated hygrostat
and connection ports for
condensate drainage provided by
the customer ensure continuous
fault-free operation.
The units are reliable, easy to use
and conform to the fundamental
health and safety requirements of
the appropriate EU stipulations.
The units are used in all locations
where dry air is a must and where
economic consequential damage
(such as that caused by mould)
must be prevented.
Operating sequence
The unit is switched on and off
using the integrated hygrostat.
The hygrostat is set to
60 % RH in the factory.
The respective unit function is
indicated by a multi-colour LED
display on the front of the unit.
The fan extracts the moist room
air via the lower part of the front
panel.
Heat is removed from the room air
on the cold
evaporator.
The air is
then cooled to below dew point.
The water vapour contained in
the room air is then deposited
as condensate or rime on the
evaporator fins.
On the
condenser
, the cold and
dehumidified air is warmed up
again and discharged back into the
room via the top part of the front
panel with a temperature increase
of around 5 K above the room
temperature.
The processed, dry air therefore
continuously mixes with the room
air.
Continuous circulation of the room
air through the unit gradually
reduces the relative humidity
(% RH) in the room to the desired
humidity level.
LED light function
If the unit was delivered with the
LED light function, the light can
be switched on and off using an
operating switch at the top right
corner of the panel. If designed as
an RGB-LED, a remote control is
also supplied.
LED light function
LED operating switch
7