3. If coupling was successful, the
unit sends a serial number to the
wireless remote control and the
wireless symbol is displayed.
4. The swimming pool
dehumidifier confirms the
connection by displaying the code
“Conn” for a period of 3 seconds.
This procedure can also be carried
out using several remote controls
so that an air dehumidifier can
be controller by several remote
controls.
Connecting the antenna
The antenna is located on the
control board inside the unit or
can be fitted there. This will be
pre-installed if the unit is delivered
together with the remote control.
Before fitting the antenna,
disconnect the unit from the
power supply. Then loosen the two
locks on the bottom of the unit by
turning them anticlockwise, tilt the
front cover of the unit and lift it
up. In the upper right area, remove
the two screws on the board cover
and remove the cover. Pull the
control board forwards, screw
the antenna into place and bend
it forwards. Once the antenna is
screwed in place and the board
has been returned to the previous
position, the unit can now be
provided with power in order to
couple it with the wireless remote
control. Then screw the housing
parts back into place.
Switching on and coupling the
remote control
The wireless remote control must
be coupled with the unit before it
can be used. To do so, carry out
the following steps.
1. Insert the batteries provided into
the battery compartment on the
rear of the wireless remote control.
2a. The remote control will search
for the unit for two minutes.
During this time, the remote
control display flashes every
2 seconds.
2b. During the search phase, hold
down the Up and Down keys on
the operator panel of the control
board at the same time for 5
seconds.
Coupling
Connecting the antenna
Location of the control board
Coupling failure
If the wireless remote control fails
to couple with the unit, the fault
symbol becomes visible, “Conn” is
shown permanently on the display
and the wireless symbol flashes.
The wireless remote control
needs to be reset before a new
coupling attempt can be made.
To do so, hold the Left key on the
wireless remote control down for
10 seconds.
16
REMKO SLE 45-85