130-01 Operations
Refraction Technology, Inc.
88
5.3
RT527 Scope
This document describes the handling of calibration issues using the RT527
Sensor Control Board (SCB). This board is an optional board which contains
circuitry to support the reporting of auxiliary channel data, mass re-
centering and calibration signal output for two sensors. For more information
on sensor control see Section 8 in the 130 Theory of Operations.
5.3.1
Channel Connector Signals
Each channel connector of the REF TEK 130-01 has the following pin-out:
Pin
Name
Direction
Description
A
Ch1 +
In
Channel 1 Input +
B
Ch1
In
Channel 1 Input
C
Ch2 +
In
Channel 2 Input +
D
Ch2
In
Channel 2 Input
E
Ch3 +
In
Channel 3 Input +
F
Ch3
In
Channel 3 Input
G
AGnd
-
- Analog Ground
H
Pwr Out
-
Sensor Power (+12V)
J
PGND
-
- Power Ground
K
CalEn -
Out
Calibration Enable - active low (GND) (CMG
sensors)
L
CalEn +
Out
Calibration Enable - active high (+5v) (STS
sensors)
M
Center -
Out
Center Enable - active low (+5v) (CMG sensors)
N
CalSig
Out
Calibration Signal (+/- 5v)
P
Aux 1
In
Aux (Mass Position) Channel 1
R
Aux 2
In
Aux (Mass Position) Channel 2
S
Aux 3
In
Aux (Mass Position) Channel 3
T
DGND
-
- Digital Ground
U
Out
Center Enable - Active High (+5V) (STS sensors)
V SID
In/Out
Sensor
ID
Note: The CalEn and Center pins are tri-state under normal operation conditions.
These pins are driven to their stated output level when in active use.
Summary of Contents for 130-01
