Reely HCP80, Operating Instructions Manual

Page: 99 / 240

99
c) Basic Trimming „SUB TRIM“
Often, the interlock at the servo sticks is very coarse, so that the required mechanical position of the servo stick cannot
be set without changing the trimming. The basic trimming permits setting the servo so that the position of the servo
stick is correct and the trimming display still stays in the middle position. Only then will you be able to perform fine
trimming in both directions using the trim buttons during flight (see fig. 1, item 5, 6, 15 and 16).
Generally, the mechanics should always be set so that the trim
and the basic trim need to be moved from the centre position
as little as possible for the model to fly straight.
Important!
Before setting the basic trim, check with the operating
display whether the four trim displays are set cen-
trally.
To set the basic trim, proceed as follows:
• Call the function settings menu.
• Select the menu item „SUB TRIM“ with the buttons „UP“ or
„DOWN“.
• Activate the menu item with the button „SELECT“.
In the display you will see display items for the first four
control functions with the respective currently set basic trim
values. The triangle pointing to the right shows the value that
can be set at the moment.
• Pushing the buttons „INC (+)“ or „DEC (-)“ sets the described
trim value for the roll servo. The setting is saved automati-
cally.
• Pushing the button „CLEAR“ will call the set value specified
ex works again.
• Push the button „SELECT“ so that the triangle pointing to the
right will jump by one position and you can set the described
trim value for the nod servo to the left.
• Repeat the above procedure until the trim values of all six
control functions have been programmed.
• Push the buttons „UP“ and „DOWN“ at the same time to re -
turn to the overview of the function setting menu.
Figure 34