Reechcraft PowerPole, Operators Safety Manual

Page: 44 / 48

44
secti
On
TRANSPORT, STORAGE, AND MAINTENANCE
7
DAILY INSPECTION AND MAINTENANCE LOG (2 OF 2)
Component OK Inspection/Action
Gearbox
Inspect input shaft for wear or damage. If hex is rounded or
damaged in any way replace immediately.
Lock Lever
Inspect the lock lever for any damage or excessive wear.
Ensure torsion spring returns the lock lever to rest position
freely and quickly. Inspect to make sure that bolts are tight
and securing the lock lever assembly to the traveler. While
raising the climbing unit, listen for audible ratcheting pattern.
Pattern should be uniform both in volume and frequency.
Drill Bracket
Inspect the drill bracket for any damage or misshapen parts.
Check that bolts are securely fastening the drill bracket to the
traveler. Fasten the drill to the gearbox using the drill brack-
et. Be sure the drill assembly with driver freely moves on to
hex input shaft of the gearbox and engages fully. Secure the
drill to the drill bracket by tightening the wing nut.
Platform
Support
Inspect all platform and bench supports for any loose
connections or damaged components. Ensure the supports
are connected securely to the climbing unit, inspecting the
bolt connections or locking pins that secure them to the
traveler. Be sure all hardware used for adjustment is present
and functioning properly.
Masts
Inspect mast for damage and straightness. Discard and
replace as necessary.
Standoff Tie
Inspect the entire standoff tie for any loose connections,
misshapen, broken or damaged parts. Be sure that the mast
swivel joint pin is secure and that the adjustment knob for
the mast is in good working condition. Discard and replace
parts as necessary.
V-Brace
Inspect the entire v-brace for any loose connections,
misshapen, broken, or damaged parts. Be sure the
adjustment knob and bolt are in good working order. Check
to ensure the locking pins are properly engaging into the
channels. Make sure the bolts are securely fastened.
Outrigger
Base
Inspect the pivot joint bolt and make sure they are secure.
Check the brackets that fixture to the mast. Be sure they are
not damaged and that the adjustment nut, spacer, and bolt
are present and functioning properly.
Work
Platform Inspect that guardrails are in place and functioning properly.
Test both swinging gates to ensure the close properly.
Drills
Check cords and nut driver. Be sure that nut driver is securely
fastened. Discard or repair any damaged electrical cords.
Cords,
Powerboards
Check for any damage. Discard or repair immediately.