Raymarine hsb2 Series, Owner'S Handbook Manual

Page: 137 / 231

6-6 HSB Series Color LCD Display
Ma
n Ove
rboar
d
(M
O
B
)
6.4 Man Overboard (MOB)
If you lose a person or object overboard, and need to return to the location, you
should use the Man Overboard (MOB) function.
You can select the type of data used for the MOB position using the set up
menus (see
Section 7.3 ).
Note: To obtain MOB position, you need either of the following:
• Position data from a GPS or equivalent device
• Heading and speed data, so that the position can be calculated by dead
reckoning
➤
To initiate the MOB procedure, press and hold the
MARKS
key for two
seconds. The system then performs the following tasks automatically:
• Redraws the chart at 1/2 nm (even if cartography is not available but plotter
mode is on).
• Marks the current position with a MOB symbol which replaces any
current active waypoint and route.
• Displays the MOB data box, showing the bearing and distance from your
vessel to the MOB waypoint position, and the elapsed time since the MOB
was initiated (
Figure 6-3 ).
• Displays the position data box, showing your vessel’s position.
• As your vessel moves from the MOB position, a dotted line is displayed
connecting the MOB symbol and the vessel’s current position.
• Sounds a 4-second alarm pattern every 30 seconds.
• Sends an MOB message (including bearing and distance) to other units in
the system, via the SeaTalk connection.
Figure 6-3: MOB Display
MARKS
D4273-2
RNG
0.33
nm
BRG
162°
T
00:05:24
MOB
MOB data box
MOB position
POSITION
N 49°54^76
W 002°09^83