Raymarine hsb2 Series, Owner'S Handbook Manual

Page: 187 / 231

8-26 HSB Series Color LCD Display
Sea
Ta
lk
®
and
NMEA In
The SeaTalk input/output should be connected at the rear SeaTalk 3-pin
connector. This appears as follows, when viewed from outside:
Figure 8-15: SeaTalk Connector
Note:
1 . The display does not supply 12 V via the SeaTalk connector, neither does the
SeaTalk connector require 12 V to operate.
12 V is required for other SeaTalk units (except where SeaTalk is connected
only between two HSB displays).
2 . If you are connecting an active compass to the radar, the NMEA input has
priority. You should, therefore use an NMEA input channel (see Power and
NMEA Input Connection) rather than the SeaTalk interface, unless the com-
pass only has a SeaTalk output.
To connect the display unit to the SeaTalk bus, connect a standard SeaTalk
cable between the SeaTalk connector on the rear of the display and a SeaTalk
instrument or the SeaTalk bus.
Standard SeaTalk cables are available in a range of lengths (part numbers
W284 to W287), and cables for connecting to SeaTalk units with round
connectors are also available (part numbers D187 or D188), see
Section 8.2
for further details .
NMEA 0183
The NMEA 0183 Data Interface Standard was developed by the National
Marine Electronics Association of America. It is an international standard that
enables equipment from many different manufacturers to be connected
together and to share information.
Table 8-5: Sea Talk Connections
Pin No. Function Color
1 +12 V Red
2 0 V Screen
3 Data Yellow
1. Red (No internal connection)
2. Screen (0V)
3. Yellow (Data)
SeaTalk In/Out
D3232-3