Chapter 5
Hydraulic drive
510 Hydraulic block layout
511 Component drawing: Hydraulic block layout
520 LS relief at the hydraulic block
530 Proportional valve venting
540 Oil motor drive unit disassembly
550 Gearbox oil change
560 Pressure sensors
561 Pressure sensor 40 bar - old version
562 Pressure sensor 40 bar- new version
563 Pressure sensor 250 bar
Chapter 6
Test/Diagnosis
610 Voltage supply check
620 Drop point calibration check
630 Metering slide calibration check
640 Weigh cell calibration check
650 LIN actuator check
660 Speed sensor check
670 Pressure sensor check
680 BUS communication check
Chapter 7
Troubleshooting, advanced settings
710 Alarm message overview
720 Idle measurement is interrupted, idle measurement is not fully completed
721 As of SW 3.00.00: Idle measurement is not completed
730 Flow factor increase on both sides
740 Flow factor decrease on both sides
750 Flow factor increase or decrease on one side
