09/01/2014
01C-01
S-7S HORIZONTAL STABILIZER AND ELEVATOR
ASSEMBLY AND INSTALLATION
FIT-UP AND PRE-COVERING ASSEMBLY
(BEFORE PRIMING OF HORIZONTAL STABILIZER AND ELEVATOR
FRAMES)
1.
The elevator hinges must be secured in position. Temporarily bolt the
elevators to the horizontal stabilizers.
NOTE: There are left and right
stabilizers and elevators.
The stabilizers have bushings for fuselage
attachment. These bushings are on the upper side of the frame. The right
elevator is identified by the trim tab hinges and the 3 welded tangs (trim
servo attach). Refer to
FIGURE 01C-01
.
2.
Adjust elevator left and right to create a 3/16” to 1/4” gap between the tip
of the horizontal stabilizer and the overhang of the elevator.
3.
With the elevator correctly positioned, slide each retaining collar against
the hinges. Position the retaining collars to allow the hinge to swivel freely
with minimal play.
4.
Locate and drill a # 30 hole on the interior side of each retaining collar
through the leading edge spar of the elevator.
5.
Rivet in position as per parts manual and disassemble elevators from
horizontal stabs.
6.
Mark and drill the aft hole for the elevator horn attach on both elevators.
Refer to
FIGURE 01C-01.
Temporarily bolt the control horn to the forward
attach hole already drilled at the factory and use it to mark the aft hole
location on the centerline of the tube. Take horn off and drill both elevators
# 11.
7.
Prep and prime horizontal stabilizer and elevator frames.
Summary of Contents for S-7S COURIER
