Rans S-7S COURIER, Text Manual

Page: 105 / 203

09/25/2014
05D-03
18. The Flaps must move freely without rubbing on the Gap Seals. A minimum
clearance of 0.060” must be maintained between Gap Seal and Flap
Leading Edge. Final fit the Gap Seal by filing, sanding, or planeing until
proper clearance is obtained.
HINT: A miniature Wood Plane works great
to shave off excess material.
19. Trim the Aileron Push-Pull Tube Exit and Flap Teleflex Cable Exit to lay
flat on the Wing. Trim out the AFT opening of the Aileron Push-Pull Tube
Exit. Refer to
FIGURE 05D-19 . NOTE: Cutouts in the Flap Cable Exit will
be made during WING INSTALLATION .
20. Center the Exits on the Exit Reinforcement Rings on the Wing. Transfer
drill #40 through the dimpled locations on the Exits. Cleco as you drill. Do
NOT install the Exits at this time. For Exit installation and connection of
Aileron Push-Pull Tubes and Flap Cables refer to WING INSTALLATION .