Rans S-7S COURIER, Text Manual

Page: 50 / 203

09/01/2014
01H-03
19. Install the oil tank vent tube using the clamps and spacers in the
appropriate mount holes as shown.
NOTE: The small hole in the overflow
tube is there to provide a source of venting in case the main opening is
plugged.
Tighten the clamps so that it is still possible to move the tube up
and down. NOTE: The vent and overflow tubes must be temporarily
moved up, when the boot cowl is installed. After that, move them down
and tighten clamps. Also, note all cut off angles of the tubes should face
aft.
20. Install the four adjuster cable ferrules with supplied stop nuts in the
appropriate mounting holes as shown.
IMPORTANT Place each ferrule at
the approximate middle of its adjustment range.
AFT SIDE FIREWALL ITEMS INSTALLATION
21. Refer to FIGURE 01H-21 for aft side mounted items.
22. Install the four 90-degree fittings in the parking brake valve using thread
sealant or Teflon tape.
IMPORTANT: Drill the hole in valve arm to 1/4”.
Install the cable swivel stop into the valve arm. Bolt the valve to the aft
side (cabin side) of the firewall in the appropriate position.
23. Install the cable housing swivel stop into the cable housing swivel stop
bracket. Align with swivel in parking brake valve. Rivet bracket to firewall
as shown.
24. Install the 90-degree fitting and the “T” fitting in the firewall as shown. Use
thread sealant or Teflon tape.
25. Install the 3 bus bars to the aft side (cabin side) of the firewall as shown.
26. The firewall should now be installed to the airframe, if not already done.