Rans S-7S COURIER, Text Manual

Page: 199 / 203

06/22/06
11B-02
Run a 14-gauge wire from the NAV switch back to the strobe box area. Connect
a brass "Y" to the end of the wire. The 14-gauge wire coming out of each wing
will connect to the "Y".
NOTE: Wrap the “Y” with electrical tape, after connection,
to prevent shorting. Run a 14-gauge wire from the strobe switch back to the
strobe box. Also, run a 14-gauge wire for the ground buss. Connect these wires
to the black and red wires coming out of the strobe box.
NOTE: Remember to
connect the ground wire to the strobe shield wires. Check all connections and
wires.
STROBE / POSITION LIGHT INSTALLATION
(BEFORE PAINTING OF WING TIPS)
Refer to
FIGURE 11B-02
Rivet the Navigation Light Mount to the wing tip per FIGURE 11B-02 . Use the
nutplate rivets to retain the mount plate. Drill the three (3) mounting holes in each
Strobe Light Assembly to #11. Trial fit.
(AFTER PAINTING OF WING AND PRE-INSTALLATION OF WING TIPS)
Refer to
FIGURE 11B-03
Secure Strobe / Navigation Light to wing tip. Cut out the 4” inspection panel in
outer wing skin. Pull wires taped to inside of tip bow through inspection hole.
Connect plastic plugs from strobe and gray wire. Secure connector with
electrical tape or plastic tie wrap to prevent disconnection.
Connect Red and Blue Power wires from NAV lights to 14-gauge NAV power
wire. Ground the Black and Blue Ground wires from the NAV lights back to the
Ground Buss. Install Wing Tip. Check Strobe and NAV lights for proper
operation.