Ranger Products RL-8500, Installation And Operation Manual

Page: 24 / 54

24
MAKE SURE THE DRUM / ROTOR CROSS FEED
SWITCH IS IN THE NEUTRAL POSITION.
KEEP HANDS clear of moving parts at all times. Keep
hair, loose clothing, neckties, shop rags, jewelry, fingers,
and all parts of body away from moving parts.
Always wear safety glasses or a face shield. Cutting
an exposed surface such as a brake drum, rotor
or flywheel will produce flying chips and debris.
14. Turn the main Power Switch on.
15. Move the Feed Selector switch to the Rotor position.
16. Set the Speed Feed Dial to 4- 6.
17. The Cross feed is feeding properly when the Cross
Feed Handle Wheel is not turning.
When the Cutter is finished.
18. Set the Speed Feed Dial to 0.
19. Move the Feed Selector Switch to Neutral.
20. Turn off the Main Power Switch.
21. Loosen the Cross Feed Hand Wheel lock.
22. Back off the Twin Cutter head Assemble by turning
the Cross Feed Hand Wheel counter clock wise.
23. Check the machined surface.
If your cutting bits are in good condition and the feed rate
was set at six or below. The finish should be excellent.
If necessary, perform another pass until the finish is
acceptable.
When the machining is complete.
1. Remove the Silencer Band.
2. Loosen the Locking Nut using the spanner wrench.
3. Remove the Locking Nut.
4. Remove the Centering Cone.
5. Remove the Rotor.
If you are turning more hubless rotors or drums you can
leave the Quick Change Adapter on the machine.