Ranger Products RL-8500, Installation And Operation Manual

Page: 34 / 54

34
STEP 15
(Boring Bar Set Up)
(for Flywheel Machining)
1. If necessary, remove the Rotor Cutter Assembly.
2. Rotate the Cross Feed Hand Wheel clockwise until
the Cross Feed is almost all the way in. Then Turn the
Cross Feed hand Wheel counter clockwise two turns.
3. Clean the mounting Surface.
4. Loosely mount the Drum Tool Bar Assembly.
NOTE:
You may have to reverse the Tool bar Clamp
Assembly to get the Cutter in the proper position.
The Cutter should be as close to 90 ° to the face
of the flywheel as possible.
NOTE:
Some Flywheels can use the Quick Adapter System
for mounting of the flywheel. Mount as you would
a rotor using the appropriates cups and or backing
plate as needed.
For illustration purposes the flywheel will be mounted
without using the Quick Change Adapter System.
Remove the Quick Change Adapter System by reversing
the steps shown in Step 5.
NOTE:
Some smaller flywheels can be turned using
the inner Cutter on the Twin Cutter. Follow the
procedures as outlined in the Rotor Section, using
only the inner Cutting Tip.
STEP 16
(Mounting Flywheels)
1. Clean the Arbor make sure it is free of all debris.
2. Slide the Bell Clamp onto the Arbor.
3. Ensure all pins and bolts are removed from the
flywheel prior to mounting.
4. Remove any debris from the Flywheel.
5. Mount the Flywheel onto the Arbor.
6. Mount the Centering Cone.
7. Use spacers as needed to fill up the space on the
Arbor so the Arbor Nut will tighten the flywheel against the
Cup.