Ranger Products RL-8500, Installation And Operation Manual

Page: 16 / 54

16
STEP 5
(Mounting the Quick Change Adapter)
Most Hubless drums and rotors can be mounted using the
Quick Change Adapter. Refer to the Set up Configuration
Guide on the next page for Hubbed configurations.
1. Wipe the Arbor clean of any debris.
2. Mount the Locator onto the Arbor Shaft.
3. Mount the 2 inch Spacer
4. Mount the Self Aligning Spacer.
5. Mount the Arbor Nut, (reverse threaded) and hand
tighten.
6. Tighten the Arbor Nut using the Wrench.
IMPORTANT NOTE !
The Self-Aligning Spacer should always be used
next to the Arbor Nut when tightening. To avoid
overtightening, wrench turn the Arbor Nut counterclock-
wise until the drum and /or adapters become fixed snug
on the Arbor and so that you are unable to freely turn
them. Then continue to advance the wrench 1/4 of a turn
only. DO NOT overtighten the Arbor Nut.
Handle Adapters With Care
The adapters, arbor, and spindle are made
of top grade steel, hardened, and precision ground to
close tolerances. Great care should be taken in their use,
handling, and storage. The smallest nick or scratch can
cause incorrect drum, rotor or flywheel alignment, resulting
in inaccurate resurfacing.