Ranger Products RL-8500, Installation And Operation Manual

Page: 38 / 54

38
15. Move the Feed Selector switch to neutral when the
machining is finished.
16. Set the Speed Feed dial to 0.
17. Turn off the Main Power Switch.
18. Loosen the Spindle feed Hand Wheel lock.
19. Back off the Cutter Bar Assemble by turning the
Spindle Feed Hand wheel counter clockwise.
Check the machined Surface.
If your cutting bits are in good condition and the feed rate
was set at six of below, the finish should be excellent.
When the machining is complete;
1. Loosen the Spindle Feed Hand Wheel Lock and the
Spindle Feed Lock Knob back the Tool bar out of the
way.
2. Loosen the Locking nut using the Spanner wrench.
3. Remove the Locking Nut
4. Remove the Centering Cone
5. Remove the Flywheel.
KEEP HANDS clear of moving parts at all times.