Ranger Products RL-8500, Installation And Operation Manual

Page: 13 / 54

13
STEP 2
(Basic Set Up)
1. Install the Long Arbor Bolt into the Spindle.
2. Install the Arbor into the right end of the Spindle.
Check to make sure the alignment mark on the Arbor
lines up with the mark on the Arbor Chuck.
3. Hand tighten the Arbor Bolt. Double check the
alignment of the Arbor with the tick mark in the Arbor
Chuck. Tighten the Arbor Nut with the supplied wrench.
4. Install the Cutting Tips into the tool holders and the Tool
Holders into the Cutting Assembly. Always extend the
Tool Holders the minimum required to perform the
cutting operation.
5. Install the Twin Cutting head on the Cross Feed base.
Hand tighten the Lock Nut.
6. The RL-8500 is shipped WITHOUT OIL . BEFORE any
operation check the oil level by viewing the sight glass
located on the front of the lathe. Then check that the drain
plug is tight. Refer to the Maintenance section on page 40
& 41 for filling instructions.
7. Check that the Main Power Switch is off.
8. Plug in the electrical power cord.