Ranger Products RL-8500, Installation And Operation Manual

Page: 33 / 54

33
14. Set the Speed Feed Dial to 4- 6.
15. Move the Feed Selector switch to neutral when the
machining is finished.
16. Turn off the Main Power Switch.
17. Set the Speed Feed dial to 0.
18. Loosen the Spindle Feed Handle Wheel lock.
19. Back off the Cutter Bar Assemble by turning the
Spindle Feed Hand wheel counter clock wise.
Check the machined Surface.
If your cutting bits are in good condition and the feed rate
was set at six of below, the finish should be excellent.
If necessary, perform another pass until the finish is
acceptable.
When the machining is complete.
1. Remove the Silencer Band.
2. Loosen the Locking Nut using the spanner wrench.
3. Remove the Locking Nut.
4. Remove the Cup with the built in Spring.
5. Remove the Centering Cone.
6. Remove the Drum.
If you are turning more hubless rotors or drums you can
leave the Quick Change Adapter on the machine.