Ranger Products RL-8500, Installation And Operation Manual

Page: 28 / 54

28
STEP 11
(Boring Bar Set Up)
(for Machining Drum)
If necessary, remove the Twin Cutter Assembly.
1. Clean the Cross Feed mounting Surface.
2. Loosely mount the Drum Tool Bar Assembly.
3. Be sure that a proper tool bit is secure in the Boring bar
and the cutting tip is not excessively worn. Sharp cutting
tips must be used at all times. A dull cutter will affect the
finish of both drums and rotors. If the cutting edge is
damaged, replace it promptly. Be sure no metal chips are
under tip when changing tips.
STEP 12
(
Drum Mounting)
1. Clean the surface of the Hubless adapter.
2. Mount the proper size backing plate onto the Hubless
Adapter.
3. Remove any debris from the drum.
4. Mount the drum onto the arbor.