RANA Systems Elite Controller, User Manual

Page: 16 / 328

ELITE SERIES USER MANUAL INSTALLATION
you controller in that slot.
3. Insert the gold covered “fingers” into the
slot and GENTLY rock the controller card into a
firmly seated position.
4. Adjust your ribbon cables so they pass easily
out through the back of the computer through the
vertical openings in the rear of the case.
5. If you wish to install a second controller
card, the same procedure outlined above would be
used; except the “standard” slot number for
second controllers is slot five. A third
controller would normally go in slot four.
6. Replace the lid, remembering to slide the
front edge into the case first, then press down
on the two rear corners until they pop into
place.
7. Your Elite product is now installed and the
Apple II can be turned on. Your disk drive(s)
can be placed in a convenient location, usually
along side or on top of the computer.
See figures 1. and 1.2 for correct cable connec-
tions to the Elite and Disk If controller cards.
Page 1-3