© 2005 SANDVIK TAMROCK CORP.
Page 12 - OPERATION
Safety
S 83 STD
4. SAFETY
4.1 GENERAL SAFETY
All mechanical equipment can be hazardous if operated without due care or correct
maintenance. Most accidents involving machine operation and maintenance are
caused by failure to observe basic safety rules or precautions. An accident can often
be avoided by recognizing potentially hazardous situations before an accident oc-
curs.
Because it is impossible to anticipate every possible circumstance that might in-
volve a potential hazard, the warnings in this guide and on the machine are not all
inclusive. If a procedure, tool, working method or operating technique not specifi-
cally recommended by manufacturer is used, you must satisfy yourself that it is safe
for you and others. You should also ensure that the product will not be damaged or
made unsafe by the method of operation or maintenance procedures you choose.
Safety is not just a matter of responding to the warnings. All the time you are work-
ing with your attachment you must pay attention to what hazards there might be and
how to avoid them. Do not work with the product until you are sure that you control
it. Do not start any job until you are sure that you and those around you will be safe.
Warning! Read the following warning messages carefully. They tell you of dif-
ferent hazards and how to avoid them. If proper precautions are not taken you
or others could be seriously injured.
4.2 SAFETY INSTRUCTIONS
MANUALS
Study this manual before installing, operating or maintaining the product. If there is
anything you don't understand, ask your employer or your local dealer to explain it.
Keep this manual clean and in good condition.
Study also the operating and maintenance manual of your carrier before operating
the attachment.
CARE AND ALERTNESS
All the time you are working with the product, take care and stay alert. Always be
careful. Always be alert for hazards. The possibility of a serious or even fatal acci-
dent is increased when you are intoxicated.
Summary of Contents for S 83 STD
