RAMMER S 83 STD, Operation And Maintenance Manual

Page: 16 / 58

© 2005 SANDVIK TAMROCK CORP. Page 16 - OPERATION
Safety S 83 STD
LIFTING EQUIPMENT
You can be injured if you use faulty lifting equipment. Make sure that lifting equip-
ment is in good condition. Make sure that the lifting tackle complies with all local
regulations and is suitable for the job. Make sure that the lifting equipment is strong
enough for the job and you know how to use it.
Do not use this product or any of its parts for lifting. See “Lifting instructions” on
page 8. Contact your carrier dealer to find out how to lift with your carrier.
SPARE PARTS
Use only genuine spare parts. Use only genuine tools with hydraulic hammers. The
use of other spare part or hammer tool brands may damage the product.
EQUIPMENT CONDITION
Defective equipment can injure you or others. Do not operate equipment which is
defective or has missing parts.
Make sure the maintenance procedures in this manual are completed before using
the product.
REPAIRS AND MAINTENANCE
Do not try to do repairs or any other maintenance work you do not understand.
MODIFICATIONS AND WELDING
Non-approved modifications can cause injury and damage. Contact your local deal-
er for advice before modifying the product. Before welding on the product while it
is installed on the carrier, disconnect the carrier alternator and battery. Note that
welding of the hammer tools will render them useless and make the warranty void.
METAL SPLINTERS
You can be injured by flying splinters when driving metal pins in and out. Use soft-
faced hammer or drifts to remove and fit metal pins, such as pivot pins. Always wear
safety glasses.