DRAFT
Operator’s Manual
© Copyright 2014 - Rail-Ability Limited
Page
38
of
64
Conversion
Figure 22 - Force Values Password Page
To allow access to the “Force Values” page, the appropriate 8 digit pass code must first be entered
when attempting to access the page via the main menu. The up, down, left, and right keys on the
screen dial will navigate through the numbers, once the required number is selected, press the “
ok
”
button to enter it as a pass code digit. Highl
ighting and using the “DEL” button will remove the
previously entered pass digit. The F4 key will return the screen to the main menu page. Once the key
has been entered, it will not be required to be re-entered unless the system is shutdown (at vehicle
ignition off, for example).
Figure 23 - Force Values Page
Having entered the correct pass code (different from the Gauge Locks page code), hold the “
ok
”
button to activate the required outputs, using the up and down arrows to navigate through the options,
and F4 to return to the I/O Status menu page. Use the F1, F2, and F3 keys to access more system
variables, and groups of variables value forcing pages respectively at the initial force values page. The
“
ok
”
button will set the outputs on or off, and keep them set until they are reset by returning to the
page to toggle their state with the “
ok
”
button input. These pages must only be used for vehicle
component testing and initialisation; there should be no need to access these pages under normal
operation of the system.