DRAFT
Operator’s Manual
© Copyright 2014 - Rail-Ability Limited
Page
34
of
64
Conversion
12.5.8 Axle Selection
Figure 15 - Front/Rear Axle Selection Page
Upon selecting the required rail axle, the other half of the machine will become hidden, and the screen
will display as either of the two states shown above.
12.5.9 Axle Control
Figure 16 - Front/Rear Axle Control Page
After selecting the required axe, w
hile holding the “
ok
” button the screen will change to the control
pages as shown above. The current status of the axles is described next to the images of the
machine. The icon of two arrows next to the axles indicates that the system is ready and primed for
their movement up or down.
To raise or lower the axles, press the rail axle control button to select the axle you wish to operate,
then operate the dozer up/down lever, forwards to lower the rail axle or backwards to raise it. To
raise/lower the other axle press the rail axle control switch into the alternative position then operate
the blade lever in the same way.
NOTE: TO ENABLE THE RAIL AXLES TO BE DEPLOYED OR RETRACTED THE PROLEC RCI
MUST HAVE 'DIG MODE' ENABLED AND CAN NOT BE IN LIFTING MODE.
THE PROLEC LIFT WATCH RAIL RCI IS AN INHERENT AND INTEGRAL SYSTEM WITHIN THE
RAIL-ABILITY SAFETY SYSTEMS ON THE MACHINE. COMPLETE FAMILIARITY WITH THE
PROLEC OPERATION MANUAL IS VITAL IN COMBINATION WITH THIS MANUAL TO HAVE A
COMPLETE UNDERSTANDING OF THE MACHINES SAFETY FEATURES AND OPERATIONAL
INTERLOCKS.