Chapter 5
Configuring the Link
This chapter describes configuration procedures, which are performed
after the physical installation of the local and remote WinLink units and
after the Installation Link wizard has been run. A Link Configuration
wizard is used to redefine the configuration parameters if necessary.
Both the HQ and sites in the link are defined simultaneously (both
sides of the link are defined simultaneously).
The following parameters are configured via the Site Configuration
Wizard:
•
System parameters
•
Frequency channel
•
Air interface rate
•
Service parameters
•
TDM
•
Hub Site Synchronization Settings.
The following parameters are configured via the Configuration dialog box.
•
Transmit power
•
Management and trap addresses
•
Bridge mode
•
Ethernet mode
•
Community values.
For HSS screens see Appendix E: Hub Site Synchronization.
After installing the link, the system configuration can be modified.
