Link Configuration Wizard
WinLink User and Installation Guide
Version 1.750
5-74
The
sign on the configuration Wizard and Status bar indicates that
the radar detection is on.
Æ
To define automatic channel selection in the 5.4 ETSI version
1.
Select the main frequency from the Operating Channel menu.
Note:
Automatic Channel Selection is selected by default.
2.
Click at least two check boxes in the Available Channels List of all
the allowable channels that can be automatically selected.
Note:
Installation will not continue until at least two channels are defined.
Selecting a new channel causes the system quality to change. The
quality bar shows the adjustment until the system finds the best
quality link.
Any channel selected is evaluated for 60 seconds; therefore this
selection process may take a few minutes.
3.
If you are not satisfied with the channel that is selected
automatically, click
Reselect Channel
.
A new channel will be selected from one of the Available Channels
that have been defined.
Note:
The reselection process may take a few minutes.
4.
Click
Next.
The maximum rate is selected according to the link conditions
The quality bar may fluctuate until the system finds the best quality
link.
5.
Click
Next
.
The Service Parameters dialog box appears. Proceed to page 5-76.
