RADSON ESSENTIAL THERMOSTAT, Installation & Maintenance Manual, Page: 18 / 74

18
M16MI377 - A07-06/18
To validate, save the new value and exit the mode, press . To exit the
Expert settings, press 3 times.
2 - To save and move automatically to the next setting press .
To exit the Expert settings, press 3 times.
The reset to zero of the sensor calibration
To put the value of the correction to "0", do the following :
1- When the temperature measured by the sensor appears, press or
for at least 3 seconds.
mode
auto prog
OK
boost
3 sec.
Important:
These changes should be performed by a qualified
staff, it should be performed in production or on site during the
first installation.
Increase the temperature measured by the ambient temperature sensor
by 2°C by pressing .
In our example the measured temperature by the sensor goes
from 21°C to 23°C.
mode
auto prog
OK
boost
To have a controller adapted to the towel rails and estimate the energy
consumed, it is essantial to set the power of the device.
1- Pre set value: 500W. Select a value between 500W and 1500W by
pressing or .
mode
auto prog
OK
boost
SETTING THE POWER
3 - To save the Expert settings, press 3 times.
2 - To save and move automatically to the next setting press .
mode
auto
prog
OK
boost
RESTORING FACTORY SETTINGS
If the PIN code protection is disabled, the user, installer and expert set-
tings are re-initialized:
1- From the Power setting setting, press .
rest
appears on the dis-
play.
mode
auto
prog
OK
boost
2-
NO
flashes. Press or to select
YES
.
mode
auto prog
OK
boost
yes
= Factory settings reset
NO
= Factory settings not reset
3- Press the key for 5 seconds. The device returns to its initial confi-
guration and goes back automatically to the Auto mode.
mode
auto prog
OK
boost
5 sec.
The following factory values will be effective:
Settings Factory settings
Operating
Comfort setting temperature 19°C
Boost duration 60 min.
Keypad lock Disabled
User settings
Eco mode temperature lowering-
level
-3,5°C
Frost protection temperature 7°C
Minimum set of Comfort setting
temperature
7°C
Maximum set of Comfort setting
temperature
30°C
Maximal Boost duration 60 min.
Maximum ambient temperature
for the automatic stop of the
Boost
35°C
Temperature unit °C
Installer settings
Automatic open window
detection
Enabled
PIN code protection Disabled
Value of the PIN code 0000
Experts settings
Power 500W