Radiolink Electronic Ltd
50
Goals
Steps
Inputs
Activate
THROTTLE-
NEEDLE mixing.
Adjusting the points
as follows: to
resolve a slight lean
midrange problem:
1
：
40%
2
：
45%
3
：
65%
4
：
55%
5
：
40%
Open THROTTLE-NEEDLE
to BASIC .
again to ADVANCE
to THR-NEEDLE,
Activate the function.
to MIX.PUSH
to ON.
HELI only. Select the condition
to edit.
to COND.PUSH.
as needed.
Adjust the travels as needed to
match your engine by slowly
moving the stick to each 5
points, then adjusting the
percentage at that point until
the engine is properly tuned.
to PIONT.
Throttle Stick to P
1
，
to 40%
，
Throttle Stick to P
2
，
to 45%
，
Throttle Stick to
P 3
，
to 65%
，
Throttle Stick to
P 4
，
to 55% ,
Throttle Stick to
P 5
，
to 40%,
ACRO only . Optional: increase
mixture when throttle is applied
rapidly-ACCE.(see above for
details)
to ACCE. Push
Throttle Stick to idle
Throttle Stick to full open quickly.
Heli only: set curves for another
conditions.
to condition name
to next condition name to
edit.
Repeat above steps as needed.
Close
PART 4 GLIDER MODEL FUNCTIONS
Please note that nearly all of the BASIC menu functions are the same for airplane (ACRO setup), sailplane
(GLID 1A+1F/ 2A+1F/ 2A+2F setups), and helicopter (HELI setups). The features that are identical refer back
to the ACRO chapter. The glider BASIC menu includes MOTOR CUT and does not include IDLE-DOWN or
THR-CUT.
○
→
Note: in all cases where ACRO programming labels channel 3 as throttle, GLID programming labels
channel 3 as ARB (airbrake), since airbrakes are normally operated on channel 3 in gliders. This includes
STK-THR reading STK-ARB.
4.1 SET BASIC MENU OF GLID
