Radiolink Electronic Ltd
13
For additional details on each function, see that function’s section in this manual.
Example
Steps
Input for Example
Prepare your
airplane
Install all servos, switc
hed, receivers, etc. per your model’s instructions. Turn on
transmitter then receiver; adjust all linkages so surfaces are nearly centered.
Mechanically adjust all linkages as close as possible to proper control throws. Check
servo direction. Make notes now of what you will need to change during
programming.
Name the model
(
Note that you do
not need to do
anything to ‘save’
or store this data).
Open the Basic menu, then
open the PARAMETER
Turn on the transmitter.
for 1second to basic menu.
to choose model
Go to Model Name
to Mode
，
to Mode name
，
press PUSH to setting
Input airplane’s name
Close the Model submenu
To change first character, when proper character is
displayed, push
to select.
To move to next
character. Repeat as needed.
return to BASIC menu
Need to adjust EN
D-POINT to meet
with the related ser
vo.
In the BASIC menu find the
END POINT
to END POINT
，
press
to set
Adjust end point (EX: THRO
servo)Close the function
to Throttle
Throttle stick until carburetor closes
as desired.
until throttle arm just open carburetor
at fully throttle stick. Repeat for each channel as
needed.
With digital trims you don’t shut the engine off with THROTTLE TRIM. Let’s set up IDLE
-
DOWN and ‘throttle
cut’
Goals
Steps
Input for Example
Idle down setting: Idle
down is to lower the en
gine speed for landing,
snap rolling acrobatic
display, and launching
etc. It is preset OFF an
d mainly used to start
engine and glide, then
to avoid flameout.
From the BASIC menu choose IDLE
DOWN.
to IDLE DOWN
，
press
Activate and adjust IDLE DOWN
to MIX
，
press
，
to ON
，
press
C to center position, screen now reads
ON.
to RATE, to increase rate until engine
idles reliably but low enough to sit still.
Optional: change switch C command
to POSI
，
press
，
as you desired
press
Close the function
BASIC menu
，
again to startup
screen.
THR CUT shuts the
engine off completely
with the flip of a
switch.(Note: Do Not
assign IDLE DOWN
and THR CUT to both
position of a 2 position
switch
From BASIC menu, choose THR CUT
to THR CUT
，
press
