Radiolink Electronic Ltd
29
• To ease the learning curve, elevator and aileron may be set to the NORM or FUNC mode, with the other
channels set to OFF and controlled by the instructor.
NOTE:
• NEVER turn on the student transmitter power.
•ALWAYS set the student transmitter modulation mode to PPM.
• BE SURE that the student and instructor transmitters have identical trim settings and
control motions.
Verify by switching back and forth while moving the control sticks.
• FULLY extend the instructor's antenna. Collapse the student's antenna. (Except 2.4GHz)
• When the TRAINER function is active, the snap roll function is deactivated. Oth
er functions, such as
IDLE-DOWN and THR-CUT, which have been assigned to the same switch, are not deactivated. Always
double check your function assignments prior to utilizing the TRAINER function.
•When you select a different model, the TRAINER function i
s deactivated in the current model for safety
reasons.
2.3.14 Logic Switch Selection (LOGIC SW):
The various functions in the AT9S Pro can be selected by switch..
The Logic switch can be assigned to the functions as following: THR-CUT, IDLE DOWN, AUX-CH, TIMER,
PROG. MIX, AIRBRAKE, ELEV-FLAP, and AILE-FLAP. The logic switch can activate functions by two
switches combination. The 2 types of logic, either AND or OR, can be selected.
Adjustability:
Goals
Steps
Inputs
Turn on the TAINER system
and set up so student
has :fully functional control of
aileron and elevator to
support FLAPERON
&AILERON; normally control
of rudder to allow lowered
travel; and no throttle channel
control(with the instructor for
safety)
Open BASIC menu, then Open
TRAINER
for 1s .(If ADVANCE
again) .
to TRAINER ,PUSH
Activate TRAINER
PUSH,
to PUSH
Choose desired channels and
proper training types
past AIL and ELE(default FUN)
to THR,PUSH
，
to OFF, PUSH
to RUD, PUSH,
to NORM,PUSH
Close
Test student radio function prior to attempting to fly!
