Radiolink Electronic Ltd
51
This guideline is intended to help you get acquainted with the radio, to give you a jump start on using your
new radio, and to give you some ideas and direction in how to do with this powerful system.
Goals
Steps
Inputs
Prepare your airplane.
Install all servos, switches, receiver per your model’s instructions. Turn on
transmitter then receiver; adjust all linkages so surfaces are nearly
centered. Mechanically adjust all linkages to get as close as possible to
proper control throws and minimize binding prior to radio set up.
Check servo direction and throws.
Make notes now of what you will need to change during programming.
Select the proper MODEL
TYPE for your model. (Ex:
GLID 1A+1F)
[NOTE: This is one of several
functions that require
confirmation to make a change.
Only critical changes such as a
MODEL RESET require
additional key strokes to accept
the change.]
In the BASIC menu,
open PARAMETER
submenu.
Turn on the transmitter.
for 1 sec. to
BASIC.(If ADVANCE
again.)
to choose
PARAMETER.
Choose proper MODEL
TYPE. Ex: GLID
(1A+1F).
Confirm the change.
Close submenu.
to MODEL TYPE
，
to
GLID(1A+1F)
for 1 sec. Are you sure?
Displays.
to confirm.
Return to BASIC
menu.
Name the model
Note that you do not need to
do anything to ‘save’ or store
this data.
In BASIC menu open the
MODE SEL submenu.
to MODEL SEL.
，
to NAME.
（
1
st
character of model’s name is highlighted
）
.
Input airplane name.
Close the submenu.
to change the 1
st
character.
to confirm.
to next character and repeat.
to return.
REVERSE servos as needed
for proper control operation.
In the BASIC menu,
open REVERSE.
to REVERSE.
Choose desired servo
and reverse its direction
of travel.
(Ex: reverse rudder
servo.)
to 4.RUDD,
REV is highlighted.
for 1
sec. ‘Are you sure?’ Displays.
to confirm.
To BASIC menu.
Adjust travels as needed to
match model’s recommended
throws (usually listed as high
rates).
In BASIC menu choose
END POINT.
to END POINT.
Adjust the servos’
end
points. (Ex: flap servo).
Close the function.
to FLAP
VR(A).
，
to desired travel.
VR(A).
，
to desired travel.
Repeat as needed.
Choose D/R,EXP
to D/R,EXP
