Radiolink Electronic Ltd
52
4.2 SET GLID TYPE
TYPE: (GLID 1A+1F), GLID (2A+1F), GLID (2A+2F)
Before doing anything else to set up a glider or sailplane, first you must decide which MODEL TYPE best fits
your MULTIROTOR.
• GLID(1A+1F): The GLID (1A+1
F) MODEL TYPE is intended for sailplanes with one or two aileron servos (or
none), and a single flap servo (or two connected with a y-connector). This TYPE is meant to be a very
simplistic version to set up a basic glider without a lot of added features. Additional flight condition is available.
• GLID (2A+1F): The GLID (2A+1F) MODEL TYPE is intended for sailplanes with dual aileron servos and a
single flap servo (or two connected with a y-connector). Additional flight conditions are available. These flight
Set up dual/triple rates and
exponential (D/R, EXP).
(Note that in the middle of the
left side of the screen is the
name of the channel and the
SWITCH position you are
adjusting. Two or even three
rates maybe set per channel
by simply choosing the desired
SWITCH and programming
percentages with the SWITCH
in each of its 2/3 position.)
Choose the desired
control, and set the first
(Ex: high) rate throws
and exponential.
to CH
，
to CH2(ELEV).
A to UP position. Screen reads ELEV [UP]
to D/R
Elevator Stick.
，
to set
.
Elevator Stick.
to set.
（
Normally the same for both direction
）
to EXP
Elevator Stick
to set
Elevator Stick
to set
Set the second (Ex: low)
rate throws and
exponential.
to D/R
，
A to down position. Repeat
above to set low rate.
Optional: change dual
rate SWITCH
assignment. Ex: elevator
to SWITCH G with 3
positions.
to SW
，
to G
，
G to center.
Repeat steps above to set 3rd rate.
Move flap control from the (VR
(A)) dial to the left slider.
[VR(D)](AUX-CH) .
In the BASIC menu,
open AUX-CH.
to AUX-CH
Choose CH5. Change
primary control to VR(D).
Change other channels
as needed.
to CH5
，
to VR(D)
。
Repeat steps above to set other channels.
Close
