58
Activate BUTTERFLY.
Adjust the aileron and
flap travel to 75%
Elevator setting are
adjustable in the
B.FLY-ELE.
MIX switch is selecable
Open the BUTTERFLY
function
to BASIC .
again to ADVANCE
to BUTTERFLY,
Activate the function
SWA to UP position
to MIX
，
to OFF
Adjust the travels as
needed.
(Ex: Aileron each 75%,Flap
75%)
to AIL1
，
to 75%
，
to FLP
，
to75%
，
to AIL2
，
to 75%
，
Close
4.3.9 AILE/ RUDD MIX
You can select a pre-programmed mix which is used to mix the rudders with aileron operation or the ailerons
with rudder operation.
Aileron-to-rudder mix (AILE
RUDD): automatically creates a "coordinated turn".
Rudder -to-aileron mix (RUDD
AILE): used to counteract undesirable roll (roll coupling) that happens
with rudder input, especially in knife-edge.
ADJUSTABILITY:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron
(rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the
mix in 2 separate positions of the same SWITCH.
• Condition: The separate AILE
RUDD setting for each flight condition can be set.
Goals
Steps
Inputs
Ex:RUDD-AILE,
25%,no
switch,corrects
roll coupling.
Open AIL/RUD-MIX
submenu.
to BASIC .
again to ADVANCE
to AIL/RUD-MIX,
Select the mixing mode.
to MODE
，
to RUDD-
AILE
Activate the function
to MIX
，
to ON
Set the rate (Ex:100%
each way)
to RATE
RUDDER STICK
，
to +25%
RUDDER STICK
，
to +25%
Close
4.3.10
ELEV-FLAP mixing (see GLID menu 3.3.7)
4.3.11 AILE-FLAP(GLID 2A+2F only):
