56
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display.
Goals
Steps
Inputs
Ex: Set the maximum
travel of 35% of the
total flap travel.
Open the CAMBER FLAP
function.
to BASIC .
again to ADVANCE
to CAMBER-FLP,
Adjust the up/down trim
amount separately.(Ex: adjust
to 35%)
to FLP
。
VR (A)
，
to 35%
，
VR (A)
，
to 35%
，
。
Repeat.
Or: adjust the center position
of flap servo
to CENTER
，
to desired point.
Close
4.3.7 Camber Mixing:
This function adjusts the mixing rate of camber operation which operates the wing camber (ailerons and
flaps) in the negative and positive directions. The aileron, flap, and elevator rates can also be adjusted
independently and attitude changes caused by camber operation can be corrected.
Also the operation reference point of camber control can be offset. (PRE)
Note: Camber control is not assigned at initial.
ADJUSTABILITY:
•
Rate: -100% to +100%, with a default of +30%
•
Reference point (PRE): The operation reference point of camber control can be offset. -100% to +100%,
with a default of 0%.
Goals
Steps
Inputs
Ex: set the mixing
amount for aileron to
40%, camber control
to VR (E), reference
point to desired
point.
Open the CAMBER MIX
function.
to BASIC .
again to ADVANCE
to CAMBER-MIX,
Choose desired slider.
to VR
，
to VrA
Adjust the mixing amount for
AILE. (Ex: adjust to 40%)
to FLP
to VrA
，
to 40%,
to VrA
，
to 40%
，
