38
• ACRO/GLID Defaults: The 4 programmable curves mixes default to the most frequent choices, but can be
set to any channel.
• PROG.MIX5 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-elev.)
• PROG.MIX6 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-elev.)
• PROG.MIX7 rudder-to-elevator for pitch coupling compensation (GLID mixes default to
elevator-to-airbrake.)
• PROG.MIX8 rudder-to-elevator for pitch coupling compensation (GLID mixes default to
elevator-to-airbrake.)
• HELI Defaults:
• PROG.MIX5 aileron-to-elevator for coordinated turns
• PROG.MIX6 aileron-to-elevator for coordinated turns
• Master: The controlling channel can only be a channel. Cannot OFFSET or dial.
• Trim: not available in curve mixes.
• Offset: not available in curve mixes.
Goals
Steps
Inputs
Set up a RUDD-ELEV curve
mix on a model that pitches
down severely at full rudder
and not at all with minimal
rudder input, and pitches worse
on right rudder than left:
Point 1: 25%
Point 2: 8%
Point 3: 0%
Point 4: 10%
Point 5: 28%
ON when
SWITCHC
is down.
LINK should be ON if model
has twin el eva t o r se rv os .
Ot he rw i s e , LIN K remains
OFF.
(Note that point 3 is 0%.
Otherwise,the elevator would
be retrimmed when the mix is
active and no rudder input is
given.)
Open an unused programmable
mix.(Ex: use PROG.MIX7 since
it is already set up for
FLAP-ELEVATOR)
to BASIC menu,
again to
ADVANCE
to PROG.MIX PUSH
7
，
PUSH
Activate the function
to MIX
，
PUSH
，
to ON, PUSH
Choose master and slave
channels.
Already RUDD. Already ELEV
Set LINK as needed( Ex:off)
Assign SWITCH and position.
(Ex:change from F to C
，
Down)
to SW.PUSH.
to C,PUSH
to POSI, PUSH.
to DOWN
Optional: set switch to
STK-THR to activate mix with
THROTTLE STICK.
to POSI
，
Throttle Stick to desired
point .
Push 1sec.to set.
Optional: set switch position to
NULL.Make mix active at all
time.Not complete with
STK-THR.
to POSI, PUSH,
to NULL
Set desired percent at five stick
points.
to POINT -1
to 25%
，
Repeat for points 2-5.
Close
3.3.3 Flaperon (ACRO/GLID 1A+1F ):
ACRO
GLID
