Radioddity GA-5E, User Manual, Page: 30 / 108

27
Selects 1 of 15 DTMF codes. The DTMF codes are programmed with so � ware and are up to 5 digits each.
(19) Scan Add (Scan Add) - MENU No.18
In channel mode, to scan the current channel, the channel must be added to the scan group.
• On: Turn on the scan func � on of the current channel.
•
O ff :
Do not scan the current channel.
(20) Scan ranger (Scan Ran) - MENU No.19
In frequency mode, the frequency sweep range can be precisely set. Input the start value and end value of the sweep
frequency through the keyboard.
EX: Enter 144146, in frequency mode, scan in the range of 144.000-146.000MHZ. Enter 430450, in frequency mode, scan in
the range of 430.000-450.000MHZ.
Note: channel mode, the set frequency range is invalid and cannot be saved.
(21) SCAN Resume Mode (Scan Mode) - MENU No.20
Thanks to this func � on, the radio can SCAN in frequency or channel mode. You can choose amongst three op � ons:
• Time-operated SCAN
Whenever a signal is detected, the radio will suspend the SCAN for 5 seconds, and then will con � nue to SCAN even if the
signal is s � ll present.
• Carrier-operated SCAN
Whenever a signal is detected, the radio will stop scanning. It will resume to SCAN once the signal will disappear.
• Search -Search SCAN
The radio will stop scanning once a signal is detected.
(22) PTT-ID (PTT-ID) - MENU No.21
With this func � on you can decide when sending the ANI-ID code in tx mode.