Radioddity GA-5E, User Manual, Page: 28 / 108

25
(7) Backlight (Backlight) - MENU No. 6
With this func � on you can adjust the auto o ff � me of the display backlight (Bright, 1-10Sec).
When the op � on is Bright, the backlight is always on, which will a ff ect the ba � ery standby � me.
Note: we suggest you se � ng 4-5s levels.
(8) Dual Watch Opera � on (D.Wait) - MENU No. 7
When this func � on is ac � vated, you can receive the frequency of channel A and channel B at the same � me.
If a signal is detected, the ▼ / ▲ pointer will blink on the corresponding channel or frequency.
Note: In Dual Watch opera � on mode, you can change the parameter of AB channel or frequency freely.
(9) Keypad beep (Beep) - MENU No. 8
When this func � on is enabled, every � me a bu � on is pressed, you will hear a beep tone.
(10) Time-Out-Timer (TOT) - MENU No.9
The TOT func � on is used to prevent a too long transmission and limits the tx � me: TOT temporarily stops the transmission if
the radio has been used beyond the max pre-set � me (for example 15s, 30s, 45s, etc).
Note: If this op � on is set to OFF, press and hold the PTT key to keep transmission.
(11) Receiving DCS (Rx DCS) - MENU No.10
DCS codes are similar to access codes and can be added to channels, so as to create a sort of personal channel. They enable
the radio to communicate with the users that are tuned on the same channel and have set the same DCS code.
You can choose amongst:
• O ff : O ff
• D023N-D754N (Normal DCS), D023I-D754I (Inverse DCS)
Note: In radio there are 208 groups of normal and inverse DCS codes. This func � on cannot be amended in channel mode.
(12) Receiving CTCSS (Rx CTCSS) - MENU No.11