Radioddity GA-5E, User Manual, Page: 21 / 108

18
a. In standby mode, press [MENU] [3][1] , “SEEK” will appear on the display.
b. Press
[MENU]
and the scan of CTCSS tones will start.
NOTES: The func � on cannot be ac � vated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.4 DCS scanning
This func � on allows scanning the frequencies with DCS code enabled.
a. In standby mode, press
[MENU] [3][2]
; the display will show “SEEK”.
b. Press [MENU] and the scan of DCS codes will start.
NOTES: The func � on cannot be ac � vated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.5 Cursor Conversion (A/B)
Directly press [EXIT] key to move the cursor up and down. Then, you can modify or con fi rm the parameters indicated by the
cursor.
Important1: The radio has a dual-frequency display func � on. In frequency mode, you will see on the display two di ff erent
receiving and transmi � ng frequencies; while in channel mode the two di ff erent channels will be displayed.
Important2: In frequency or channel mode, press the [EXIT] key to shi � between the main channel A and the sub-channel B
on the display indicates on which channel (main channel A or sub channel B) you are opera � ng.
6.6 High/low power fast selec � on
In channel mode, press [#SCAN] key to shift between High/ Low power.
6.7 Keypad lock
This func � on locks the keypad to prevent accidental pressure of the controls.
To unlock the keypad, press [
*
] for more than 2 seconds.