30
Keep pressed the [SK1] key for 3 seconds to start the alarm tone.
The following three op
�
ons can be selected:
•
Site:
the speaker emits an alarm tone but the radio doesn’t transmit;
•
Tone:
the speaker emits an alarm tone and the radio transmits it;
•
Code:
the speaker emits an alarm tone and the radio transmits it followed by ANI-ID code.
(32) Scan of frequencies with CTCSS (SEEK CTC) - Menu No. 31
The func
�
on allows scanning the frequencies with CTCSS tone enabled.
NOTES: The func
�
on cannot be ac
�
vated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(33) Scan of frequencies with DCS (SEEK DCS) - Menu No. 32
This func
�
on allows scanning the frequencies with DCS code enabled.
NOTES: The func
�
on cannot be ac
�
vated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(34) Squelch tail elimina
�
on (TAIL) - Menu No. 33
This func
�
on is used eliminate squelch tail noise between handhelds that are communica
�
ng directly (no repeater).
Recep
�
on of a 55 Hz or 134.4 Hz tone burst mutes the audio long enough to prevent hearing any squelch tail noise.
(35) Squelch tail elimina
�
on of repeater (RP-STE) - Menu No. 34
This func
�
on is used when the radio operates through a repeater; when the PTT is released, the repeater will emit the end
transmission tone to con
fi
rm it is working.
Available se
�
ngs:
O
ff
, 1,2,3,4,5,….10 to set the delay
�
me.
Note: Please disable this func
�
on in normal using, lest a
ff
ect your normal conversa
�
on.
(36) Delay the squelch tail of repeater (RPT-RL) - Menu No.35
Summary of Contents for GA-5E
