SCPI Command Reference 4-5
Arbitrary Block
Parameters
Arbitrary block parameters are used for loading waveforms into the
synthesizer's memory. Depending on which option is installed, the
Model 3152 can accept binary blocks up to 1046576 bytes. The
following command uses an arbitrary block parameter that is
loaded as binary data:
TRAC:DATA#564000<binary_block>
SCPI Command
Summary
Table 4-1 summarizes the complete SCPI command tree available
to program the synthesizer over the GPIB. Refer to earlier sections
in this manual for more complete details on each command.
Summary of Contents for 3152
