6
Introduction
1.2.3 EM1500 Factory Defaults
Every EM1500 is shipped with default values for some of the configuration parameters already set. Some
parameters have been left blank where it makes no sense to have a default, such as the IP address and net-
mask for the unit. The following table gives all of the factory defaults. To reset your unit to these defaults,
press down the reset switch for 10 seconds. Parameters that have been left blank or are zero, are not
included in this table.
Table 1-3. EM1500 Default Configuration Parameters
Configuration
Category
Configuration Parameter
Default Setting
General
Unit Name
EM1500-fac-dflt
TCP Keepalives
7200
Aux I/O
Direction/State PF0-4
In/Low
State OUT0 and OUT1
Hi-Z
Relay
Open
Network (Ethernet)
Enable Connections
ON
Use DHCP
ON
Ping configure
ON
Enable config
ON
Enable discovery
ON
Serial (Basic)
Speed
115200 (SER4) 19200 (all others)
Geometry
8N1 (all serial ports)
Flow control (Tx and Rx)
None (all serial ports)
Relay action
None (all serial ports)
Relay timer (ms)
10000 (all serial ports)
Modem Emulation
AT command set
OFF (all serial ports)
DSR/DTR control
Active (all serial ports, except RS485)
CTS/RTS control
Active (all serial ports, except RS485)
DCD control
Active (SER2 only)
RI control
OFF (SER2 only)
Use PF0-3
OFF (SER3 only)
RS232 levels
OFF (SER3 only)
Polling
Enable poll
OFF (all serial ports)
Summary of Contents for EM1500
