82
EM1500 Specifications
A.3.2 EM1500 FCC Compliance
Units that do not have a CE mark can be made FCC compliant. Place a ferrite on the ethernet cable
as close as possible to the EM1500’s ethernet jack. Loop the cable so that it passes twice through
the ferrite. The characteristic should have a maximum attenuation in the 100-350 MHz range, or
universal wideband.
The ferrite we used is the Ferrishield SS28B2032.
This equipment (the EM1500 with a ferrite attached as described above) has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures
:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Summary of Contents for EM1500
