Quincy QSV 2200, Instruction Manual

Page: 81 / 124

Section VI – Operating instructions
Quincy Vacuum Pump-QSV Series 81
• Make sure the pump outlet is not obstructed.
• Fit inlet isolation valve (IV); see section Installation proposal for the position of the valve.
• Close the valve.
• Connect the inlet pipework to the valve.
• Check the oil level, the oil level should reach the top of the oil sight glass (GI).
• If needed, top up the oil via the oil filler plug (FC).
• Take care that no dirt drops into the oil system.
• Provide labels, warning the operator that:
• The vacuum pump may automatically restart after voltage failure (if activated, consult Quincy).
• The vacuum pump is automatically controlled and may be restarted automatically.
• The vacuum pump may be remotely controlled.
• Check the programmed settings. Consult section Programmable settings.
• Verify that the inlet control valve and the blow off solenoid valve are connected to the required
compressed air supply.
• Start and run the vacuum pump for a few minutes. Check that the vacuum pump operates normally.
• Open the inlet isolation valve (IV).
6.2 Starting
Control panel Airlogic Graphic