Quantum Scalar i2000, User Manual

Page: 41 / 120

ADIC Management Console User’s Guide 33
When a device is selected, the lower part of the data panel display presents the following information:
Status/Message Area
The area at the very bottom of the screen is used to display status messages. It is called the
Status/Message Area .
In the leftmost corner of the Status/Message Area , the up time for the selected SNC is displayed. Up Time
indicates how many hours, minutes and seconds have elapsed since the SNC was last booted.
Connection Connection options for FC chips
Max Speed 1 GB or 2 GB
Status Ready or Not Ready
Link Error Statistics Header: Subsequent numbers are errors counted by
SNC on full duplex channel between two network fabric
connections
Link Failure Count Counts used in diagnostics
Loss of Sync Count Counts used in diagnostics
Loss of Signal Count Counts used in diagnostics
Primitive Sequence Protocol Error
Count Transmission word containing special control
information. A primitive sequence is recognized when
three transmission words of the same value are
received
Invalid Transmission Word Count Transmission word is 40 bits, smallest information unit
transmitted
Invalid CRC Count Cyclic Redundancy Check, an error detection algorithm
Vendor ID Vendor Name
Product ID Product Name, assigned by Vendor
Revision Vendor’s release number
Serial Number Number assigned to the device during manufacturing
Removable Yes or No
Capacity For Disk devices, Number of Blocks
Block Size For Disk devices, Size of block
Width For Tape devices, Bus width in bits
Speed For Tape devices, Bus speed