Quantum Scalar i2000, User Manual

Page: 100 / 120

92 Troubleshooting the SAN
65 Outlet air temperature or I/O processor temperature has entered alarm range
66 Fan is operating in nominal range after operating in a fault state
67 Fan speed has entered warning range (tachometer fans only)
68 Fan speed has entered alarm range (tachometer fans) or is stalled (rotor stall fans)
70 Appliance restart completed
71 Firmware upload completed
72 More than 64 initiators per FC Channel
73 Data path failover has occurred at FCn WWPN=nnnnnnnn:nnnnnnnn lun=nxn
loopId=nxn
75 Host has gone offline.
76 Has has come online.
150 The event log is about to overwrite the earliest events
Health Check Event Descriptions
100 Power supply is out of specification
102 Temperature change detected since the last report (event message indicates the
change to high, very high, reduced to high, or OK)
106 Fibre Channel interface failed health check
107 SCSI interface failed health check
109 Target device failed health check
110 Fibre Channel link status changed
111 Fibre Channel transfer failures detected since the last report
Note: Error recovery may have succeeded.
112 Blower/Fan is running in warning or alarm range
113 Power is running in warning or alarm range
114 Temperature is running in warning or alarm range
115 Network is running at 10 Mb/sec
Heartbeat Event Descriptions
Note: These event codes are not logged in the event log. Notification of these events
occurs from AMC.
200 The server could not verify the connection to the appliance
201 The client could not communicate with the server
202 The server could not communicate with the Client
203 Heartbeat communication restored
Table 2 Event Codes and Actions (Continued)
Event
Code
Description