Quantum DXi-Series Command Line Interface (CLI) Guide
6-66538-03 Rev C
November 2010
Replication CLI Commands
75
This CLI command lists the target IP or hostname for this system as a source. If a
replication target host has been configured, the CLI displays any available
replication statistics.
Output data:
List
of
all
allowed
replication
target
IP
for
this
system
as
a
source:
TargetHost
=
10.40.164.70
Encryption
=
Enabled
Adding a Target on a
Source
syscli --add targetrep --hostid <host_id> [--encrypt]
This CLI command allows the CLI admin to add or specify the replication target
IP or hostname of a DXi system for this system as a source. Optionally, the CLI
admin can specify whether to encrypt the data before replicating and sending
to the target.
Note:
The target must be configured to receive replications from this source
before you can add a replication target on this source. At least one VTL
or share should exist on the target.
Deleting a Target on the
Source
syscli --del targetrep --hostid <host_id>
This CLI command allows the CLI admin to delete the given target IP or
hostname as a replication target on this source system.
Enabling VTL
Replication Options on
the Source
syscli --enablerep vtl --name <VTL_name> [--daily <hh:mm>] [--cartbase
[--syncid <sync_id>]
This CLI allows the CLI admin to enable replication of the specified VTL on the
system as a source. The VTL name must be specified. Optionally, the daily
replication time to start and/or the cartridge base replication can be specified. If
the
--daily
option is specified, replication will occur on the time specified. If the
--syncid
option is not specified when
--cartbase
is specified, the default Sync ID
is the same as the VTL name (similar to the GUI). If no optional parameter is
specified, the replication is enabled without the daily or the cartridge base
replication options set.
Note:
The target system must have the corresponding partition configured
with a Sync ID prior to configuring the source system partition (see