![background image](http://html1.mh-extra.com/html/quantum/dxi2500-d/dxi2500-d_manual_3791090159.webp)
Quantum DXi-Series Command Line Interface (CLI) Guide
6-66538-03 Rev C
November 2010
Other System Configuration CLI Commands
159
E140002 Emailaddress
entered has invalid characters.
E140003 Missing '@' in emailaddress entered.
E140004 Username is missing in the email address.
E140005 Domain Name or Host Name is missing in the email address.
E140006 Too many '@' signs in emailaddress entered.
E140007 Must use dotted decimal domain name notation such as abc.com
E140008 Domain name cannot begin with a dot.
E140401 Hostname
Invalid.
E140402 Hostname cannot start or end with special characters.
E140403 Fully qualified hostname invalid.
E140404 Fully qualified hostname cannot contain consecutive dots.
E140405 Fully qualified hostname cannot start or end with special characters.
E1000001 Querytool failed to run!/
E1000002 Replication conf file was not found!
Networking CLI
Commands
The following networking CLI commands are available:
•
•
•
•
Enabling Jumbo Frames
syscli --enable jumbo [--dev <device>]
This CLI command allows the admin user to enable jumbo frames.
• dev: device to enable jumbo frames (e.g. bond0, bond1, eth0). If this
option is not specified, jumbo frames are enabled for both bond0 and
bond1.
Disabling Jumbo Frames
syscli --enable jumbo [--dev <device>]
This CLI command allows the admin user to disable jumbo frames.
• dev: device to disable jumbo frames (e.g. bond0, bond1, eth0). If this
option is not specified, jumbo frames are disabled for both bond0 and
bond1.
Getting Jumbo Frame Status
syscli -getstatus jumbo [--dev <device> | all]